Original ancillaries / accessories, Before first use, Changing the bits / screwdriver bit inserts – Parkside PAS 3.6 A1 Benutzerhandbuch
Seite 9: Preparing the tool for use, Switching on / off the cordless screwdriver, Changing the direction of rotation, Switching on / off the led lights
10 GB/IE
switch is in the middle position (lock).
To prevent the device from starting up uninten-
tionally.
©
Original ancillaries / accessories
½
Use only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and ac-
cessories other than those recommended in the
operating instructions could lead to an increased
risk of personal injury for you.
©
Before first use
©
Charging the rechargeable
battery on the device
(see Fig. D)
Note: The battery is supplied partially charged.
Charge the battery for at least three hours before
first use. You can charge the Li-Ion battery at any
time without risk of shortening battery life. Interrupt-
ing the charging process does not damage the
battery.
Starting the charging process:
˽
Connect the mains adapter
10
to a 230 - 240 V~
50 Hz mains socket.
˽
Connect the mains adapter
10
to the charging
socket on the device
5
.
The rechargeable battery is charged when the
battery indicator
3
changes from red to green.
Ending the charging process:
˽
Disconnect the mains adapter
10
from the
mains socket.
˽
Disconnect the mains adapter
10
from the
charging socket on the device
5
.
©
Changing the bits /
screwdriver bit inserts
Insertion:
˽
Insert the bit directly into the tool holder
9
.
Removal:
˽
Pull out the bit out of the tool holder
9
.
©
Preparing the tool for use
©
Switching on / off the
cordless screwdriver
Switching on:
˽
To start the appliance squeeze on the ON /
OFF switch
7
and then keep it pressed down.
Switching off:
˽
To stop the appliance, release the ON / OFF
switch
7
.
©
Changing the
direction of rotation
Clockwise:
˽
Slide the direction of rotation switch
1
to the
left.
˽
Press the ON / OFF switch
7
. The direction
indicator (clockwise)
2
illuminates. You can
now screw in the screws.
Anticlockwise:
˽
Slide the direction of rotation switch
1
to the
right.
˽
Press the ON / OFF switch
7
. The direction in-
dicator (anticlockwise)
4
illuminates. You can
now screw out the screws.
Lock:
˽
Slide the direction of rotation switch
1
into
the middle position. The ON / OFF switch
7
is now locked.
©
Switching on / off the
LED lights
8
Switching on:
˽
Press the ON / OFF switch (LED lights)
6
and
keep it pressed.
General safety advice for … / Before first use / Preparing the tool for use