Zanussi ZWN7140AL - Handbuch (Seite 18)

Check carefully whether the pump impeller
rotates (it rotates jerkily). If it doesn’t rotate,
please contact your Service Centre.
Put the cap back on the emergency emptying
hose and place the latter back in its seat.
Replace the filter into
the pump by inserting
it correctly into the
special guides.
Screw the pump cov-
er firmly by turning it
clockwise.
Close the pump door.
Caution! When the appliance is in use
and depending on the programme
selected there can be hot water in the pump.
Never remove the pump cover during a wash
cycle, always wait until the appliance has
finished the cycle, and is empty. When refitting
the pump cover, ensure it is securely re-
tightened so as to stop leaks and young
children being able to remove it.
Cleaning the water inlet filters
Important! If the appliance doesn't fill, takes
long to fill with water, the starting button blinks
yellow or the display (if available) shows the
relevant alarm (see chapter "What to do if..." for
more details), check if the water inlet filters are
blocked .
To clean the water inlet filters:
• Turn off the water
tap.
• Unscrew the hose
from the tap.
• Clean the filter in
the hose with a stiff
brush.
• Screw the hose back onto the tap. Make
sure the connection is tight.
• Unscrew the hose from the machine. Keep
a rag nearby because some water may
flow.
• Clean the filter in the valve with a stiff
brush or with the piece of cloth.
35°
45°
• Screw the hose back to the machine and
make sure the connection is tight.
• Turn on the water tap.
Frost precaution
If the machine is exposed to temperatures be-
low 0°C, certain precautions should be taken.
• Turn off the water tap.
• Unscrew the inlet hose.
• Place the end of the emergency emptying
hose and that of the inlet hose in a bowl
placed on the floor and let water drain out.
18
www.zanussi.com