AEG F54030VI0 - Handbuch (Seite 25)

Manual adjustment
Turn the water hardness dial to the posi-
tion 1 or 2.
Electronic adjustment
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode. Refer to
‘SETTING AND STARTING A PRO-
GRAMME’.
2. Press and hold function buttons (B)
and (C) at the same time until the in-
dicators of function buttons (A), (B)
and (C) start to flash.
3. Press function button (A).
• The indicators of function buttons
(B) and (C) go off.
• The indicator of function button (A)
continues to flash.
• Intermittent acoustic signals oper-
ate and the end indicator flashes
showing the current setting of the
water softener.
– The number of flashes of the
end indicator and the number of
the acoustic signals show the
level of the water softener.
E.g. 5 acoustic signals and 5
flashes + pause + 5 acoustic sig-
nals and 5 flashes = level 5.
4. Press function button (A) again and
again to change the setting. Each
time you press function button (A)
you go to the next level.
5. Deactivate the appliance to confirm
the setting.
6.2 Filling the salt container
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt con-
tainer (only for the first time).
3. Fill the salt container with dishwash-
er salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
ENGLISH
25