Installation, 1 closing the door, 2 replacing the lamp – AEG S83600CSW1 Benutzerhandbuch
Seite 40: 1 positioning

Problem
Possible cause
Solution
The appliance does
not operate.
The appliance is switched
off.
Switch on the appliance.
The mains plug is not
connected to the mains
socket correctly.
Connect the mains plug to
the mains socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.
The lamp does not
work.
The lamp is in stand-by.
Close and open the door.
"dEMo" appears on
the display.
The appliance is in dem-
onstration mode.
Keep pressed approxi-
mately 10 sec the OK but-
ton since a long sound of
buzzer is heard and the
display shut off for a short
while: appliance start
works regularly.
As much as the advice does not lead to result, call the nearest brand-mark service.
7.1 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
7.2 Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center .
8. INSTALLATION
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
Ambient temperature
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
40 www.aeg.com