7defrosting, Cleaning, Shutting your appliance down – Liebherr BCDv 1003 Benutzerhandbuch

Seite 4: Malfunctions, Changing over door hinges

Advertising
background image

7

Defrosting

The refrigerator compartment defrosts automatically. The water

that forms on the rear wall drains into a reservoir at the back of

the appliance and evaporates automatically through the com-

pressor heat.

Cleaning

Before cleaning always switch off the appliance. Pull out

the mains plug or remove/unscrew the fuse.

Clean the inside, equipment parts and outer walls with lukewarm

water and a little detergent. Do not use abrasive or acid cleaners

or chemical solvents.

Do not use steam cleaners because of the risk of injury

and damage.

Ensure that no cleaning water penetrates into the electrical

components or ventilation grille.

Dry all parts well with a cloth.

Do not damage or remove the type plate on the inside of the

appliance. It is very important for servicing purposes.

Shutting your appliance down

If your appliance is to be shut down for any length of time, switch

it off and disconnect the plug or remove the fuse. Clean the ap-

pliance and leave the door open in order to prevent unpleasant

smells.

The appliance complies with the relevant safety regulations and

EC directives 2004/108/EC and 2006/95/EC.

Malfunctions

You may be able to rectify the following faults by checking

the possible causes yourself:

Appliance does not function:

- Is the appliance switched on?

- Is the plug correctly fitted in the mains socket?

- Is the socket fuse intact?

Loud running noise:

- Is the appliance set up firmly on the floor?

- Does the appliance cause nearby items of furniture or objects

to vibrate? Please note that noises caused by the refrigerant

circuit cannot be avoided.

The temperature is not low enough:

- Is the temperature setting correct (see “Setting the tempera-

ture”)?

- Does the separately installed thermometer show the correct

reading?

- Is the ventilation system working properly?

- Is the appliance set up too close to a heat source?

If none of the above causes

apply and you cannot rectify the

fault yourself, contact the nearest

customer service department

stating the type of appliance ➊,

service number ➋ and appliance

number ➌ as indicated on the

type plate. The type plate is lo-

cated in the refrigerator compart-

ment on the left-hand side.

Changing over door hinges

GB

Advertising