Scarlett SC-1140 - Handbuch (Seite 4)

www.scarlett-europe.com SC-1140 4
GB INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
· Before the first connecting of the appliance check that voltage indicated on the rating label corresponds to the mains
voltage in your home.
· For home use only. Do not use for industrial purposes. Do not use the appliance for any other purposes than
described in this instruction manual.
· Do not use outdoors.
· Always unplug the appliance from the power supply before cleaning and when not in use.
· To prevent risk of electric shock and fire, do not immerse the appliance in water or in any other liquids.
· Close supervision is necessary when it is used near children or invalids.
· Do not leave the appliance switched on when not in use.
· Do not use other attachments than those supplied.
· Do not operate after malfunction or cord damage.
· Do not attempt to repair, adjust or replace parts in the appliance. Check and repair the malfunctioning appliance in
the nearest service center only.
· Keep the cord away from sharp edges and hot surfaces.
· Do not pull, twist, or wrap the power cord around appliance.
· Never attempt to take food or liquid out from the container when the blade is moving. Always wait until the motor
stops completely.
· Do not overload the appliance with a food.
· The appliance operates fast and effective. Do not operate continuously for more than 3 min.
FOOD PROCESSOR ASSEMBLING
· Before the first using, wash all removable parts in warm soapy water, rinse thoroughly and dry. Wipe the housing
with a damp cloth.
· Never immerse motor body in any liquid or wash under running water.
· Place the motor unit on a level surface.
NOTE: you must complete assembling fully; otherwise you cannot switch on device.
FOOD PROCESSOR USING
CAUTION: Do not operate continuously longer than 3 minutes with less than 1 minute intermission.
· Do not overload the appliance by putting in too much food and do not operate continuously for more than one
minute.
· Do not remove any parts during the operating.
· Place the blender jug onto the blender gear. Make sure it properly fitted.
· Put ingredients into blender jar, and close it with the lid.
· Insert beaker into the lid and then put the lid onto the blender jug. Make sure all parts securely fitted.
· Plug-in, turn the switch/press buttons to recommended speed:
"1"(low speed) for liquid ingredients mainly.
"2" (high speed) for heavier processing, i.e. liquid and solid ingredients mixtures.
The appliance will operate until it will be switched off.
- PULSE mode.
for solid ingredients mainly.
CAUTIONS:
Avoid operating the empty blender;
Never place hot ingredients into blender jar (> 70 ºC);
Ingredients must be cut into small pieces before processing in blender jar;
Never fill blender jar with a liquid over maximum level marked;
· When processing is finished, switch off, and then unplug the appliance and wait the motor will stop before
removing a food and attachments.
CLEANING AND CARE
· Switch off and unplug the appliance.
· Wash the accessories immediately and avoid soaking them in water for long periods; wash in warm sudsy water
after each use. Dry all accessories with a clean soft cloth.
· Wipe housing with a damp cloth.
· Do not use scouring pads, abrasive and harsh detergents.
CLEANING THE BLENDER JUG
· Place empty blender jug onto the motor unit and cover with the lid.
· Pour a little warm soapy water into the blender jug, and switch on PULSE mode for a few seconds.
· Remove the blender jug; rinse it under running water and dry.
· DO NOT IMMERSE THE MOTOR UNIT IN ANY LIQUID OR IN A DISHWASHER.
CAUTION: The blades are extremely sharp and therefore dangerous. Handle with caution!
STORAGE
· Be sure that the appliance is unplugged.
· Complete all requirements of Chapter CLEANING AND CARE.
Keep the appliance in a dry clean place.