Salter Brecknell LP-470 - Handbuch (Seite 42)

39
Printer
Initialization
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns green after 5 amber
blinks. (Any green will do during the 5 blinks).
 The LED color will be changed as following:
Amber  red (5 blinks)  amber (5 blinks)  green
(5 blinks)  green/amber (5 blinks)  red/amber (5
blinks)  solid green
 Always do
gap/black mark sensor calibration
after
printer initialization.
Set Black Mark
Sensor as Media
Sensor and
Calibrate the Black
Mark Sensor
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns green/amber after 5
green blinks. (Any green/amber will do during the 5 blinks).
 The LED color will be changed as following:
Amber  red (5 blinks)  amber (5 blinks)  green (5
blinks)  green/amber (5 blinks)  red/amber (5
blinks)  solid green
Set Gap Sensor as
Media Sensor and
Calibrate the Gap
Sensor
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns red/amber after 5
green/amber blinks. (Any red/amber will do during the 5
blinks).
 The LED color will be changed as following:
Amber  red (5 blinks)  amber (5 blinks)  green (5
blinks)  green/amber (5 blinks)  red/amber (5
blinks)
 solid green