Panasonic CF-VCD711 - Handbuch (Seite 8)

Software Preparation
(first time only)
The following settings are necessary to prepare the CD-ROM pack for use:
1
Add the check mark for [DMA] in [Start] - [Settings] - [Control Panel] - [System]
- [Device Manager] - [CDROM] - [MATSHITA UJDA150] - [Settings].
2
Set [L:] for both [Start drive letter] and [End drive letter] in [Reserved drive
letters].
3
Clear the check mark from [Auto insert notification] under [Options], then press
[OK]. (If the check mark is added for [Auto insert notification] , the suspend/
hibernation timeout function can not be used.)
4 At the [System Properties], press [Close]. The display will ask you to restart Win­
dows, then press [Yes].
Using the CD-ROM pack in the MS-DOS mode
To use the CD-ROM pack in the MS-DOS mode, configure the drive following the steps
below after performing the above steps I - 3. If the steps listed below are performed
without completing steps 1-3 above first, the drive will not operate properly.
1
Click the [Start] button then select [Shut Down],
2
Select [Restart in MS-DOS mode] and click [OK].
3
Open the "CONFIG.SYS" file for editing by issuing the following commands:
cd \C Enter )
edit config.sys ( Enter )
4
Move the cursor to the line containing "ATAPICD.SYS" and delete the charac­
ters "rem" at the beginning of the line. (Deleting "rem" causes the item to become
valid.)
DEVICEHIGH=C:\WINDOWS\COMMAND\ATAP1CD.SYS/D:MSCDOOO
(If this line is missing, add it.)
3
PressC Alt ) +(X) > thenC^ to save the file. Then press C Alt ) +CF ). then( X )
to exit the Edit program.