AUDIOLINE TEL 5 clip - Handbuch (Seite 24)

- Setting up -
24
telephone base (see Chapter 2, Section entitled Underside
of base unit, Item 2.). Then feed the cable out of the
telephone housing through the cable guide either towards
the top or the bottom. Secure the cable firmly in the cable
duct. The telephone works using the MF system (Tone
Dialling).
3.6 Wall mounting
Your telephone is also suitable for wall mounting. Use two
screws for fixing to the wall. Drill two holes 85 mm apart,
vertically one above the other, and leave the screws
protruding 5 mm from the wall. Now place the telephone
base over the screws and push down slightly.
When the telephone is mounted on a wall, you can hang the
receiver on the telephone without cutting off the call. A small
hook is located at the top of the receiver rest for this
purpose.
3.7 Adjust date and time
1. Press the button
y for 4 seconds.
2. Press the
y or z button to set the contrast in
the LC display.
3. Confirm with the
C button.
4. Press the
y or z button to set the Recall
time (100 ms or 300 ms).
5. Confirm with the
C button.
6. Enter the current hour by repeatedly pressing the
y or z buttons.
7. Confirm with the
C button. The display jumps to
the minutes display.
8. Enter the current minutes by repeatedly pressing
the
y or z buttons.
9. Confirm with the
C button. The cursor jumps to
the day display.
10. Enter the current day by repeatedly pressing the
y or z buttons.
11. Confirm with the
C button. The cursor jumps to
the month display.
12. Enter the current month by repeatedly pressing
the
y or z buttons.
13. Confirm with the
C button. This completes the
entries and the current data will now be shown in
the display.
Note: If the batteries are fully discharged, the time and
date must be re-entered.