AUDIOLINE Babysense 5 - Handbuch (Seite 13)

11
GB
4. Sensor pad installation:
• When using for infant not yet able to crawl, place one sensor pad as shown in illustration 3.
Make sure the sensor is placed underneath baby’s location in crib.
• When baby begins to crawl, and is able to move onto areas not "covered" by a single sensor
pad, attach the second sensor and place the two sensors as shown in illustration 3.
PLEASE NOTE: The sensors shall be placed with the marking “THIS SIDE UP” facing
upfront.
5. Pass the cord(s) of the sensor pad(s) through special openings in the holder. (see illustration
4).
6. Attach end(s) of the cord(s) to the outlets marked "SENSOR" on the back of control unit (see
illustration 5 and 6). When using one sensor pad, attach to any “SENSOR” outlet.
PLEASE NOTE: Do not attach any cable to the blocked socket, marked "DO NOT USE".
0
1 2
3
Illustration 2
2 1
3
2 1
0
Illustration 2
Sensor pads
(Under mattress)
Control unit
I llustration 3
Top crib/bed view
For babies not
yet able to crawl
For crawling babies
Top crib/bed view
(Under mattress)
pads Sensor
Control unit
llustration 3 I
op crib/bed view T
For crawling babies
yet able to crawl
For babies not
op crib/bed view T
llustration 3
op crib/bed view
For crawling babies
llustration 3 I llustration 3
Cables
I llustration 4
Control unit
holder
llustration 4 I
Cables
llustration 4
holder
Control unit
s
Installation