Silvercrest SHK 100 B2 - Handbuch (Seite 7)

9 GB/IE
Please note that, for safety reasons, the heating
pad must not be used after a fault and must be
returned to the service address indicated.
Operation
NOTE: the heating pad may smell of plastic the
first time you use it, but this will disappear after a
short period of time.
Switching on / off / Selecting
the temperature
To use the device, first connect the control unit 1
to the heating pad by plugging the plug-in
connector
2 and the plug for the control unit
3 together (see Fig. B).
Switching on:
Set the control unit 1 to a setting 1–6 to
switch on the heating pad.
Switching off:
Set Level 0 on the control 1 to switch the
heating pad off.
Selecting the temperature:
Set the highest temperature level (Level 6)
shortly before use. This heats the pad fastest.
If you are going to use the device for a number
of hours, set it to the middle temperature setting
(setting 3).
Temperature levels
Set the required temperature level on the con-
trol
1 (see Fig. A).
Setting 0: off
Settings 1+2: minimum heat
Settings 3+4: medium heat
Settings 5+6: maximum heat
Automatic switch-off
NOTE: The heating pad switches itself off automat-
ically after about 90 minutes. The LED indicator on
the control unit
1 shows “A”.
First select position “0” and after approx.
5 seconds select the required temperature level
to switch the heating pad back on.
Switch the heating pad off (Level “0”) or take
the mains plug out of the socket if you do not
wish to use the heating pad after automatic
switch-off.
Cleaning and care
Use the heating pad with the textile cover to
prevent soiling or damage to the heating pad
(particularly if using essential oils and creams).
RISK TO LIFE
FROM ELECTRIC SHOCK! Before
cleaning the heating pad, always
pull the mains plug out of the mains socket and
separate the plug-in connector
2 from the
plug for the control unit 3 (see Fig. B).
DANGER OF ELECTRIC SHOCK!
Do not reconnect the control
1 to
the heating pad until the
plug-in connector 2 and the heating pad are
completely dry. There is otherwise a risk of an
electric shock.
DANGER OF ELECTRIC SHOCK!
DANGER OF MATERIAL
DAMAGE! Do not under any
circumstances switch the heating pad on to dry
help it dry.
Do not use chemical cleaners or scouring
agents to clean the heating pad or the control
unit
1 . Otherwise the heating pad could be
damaged.
Never immerse the control unit 1 in water or
other liquids. Otherwise you might damage it.
Do not hang the heating pad up to dry with pegs
or similar. The heating pad may otherwise be
damaged.
Use a dry, fluff-free cloth to clean and care for
the heating pad and the control unit
1 .
Safety system / Operation / Cleaning and care