Silvercrest Z31281 - Handbuch (Seite 10)

10 GB/IE
Operation
j Press the Digital timer / UNIT / Alarm / -
button 4 to start the alarm function. The
Alarm symbol 18 appears in the display.
j You can switch off the alarm function by
pressing the Digital timer / UNIT / Alarm / -
button 4 again. The Alarm symbol 18
disappears from the display.
j When the set alarm time is reached, an
audible alarm signal sounds for about one
minute.
j No audible alarm signal sounds if the set
time is reached when the device is in the
weighing mode. Instead the Alarm symbol 18
flashes in the display.
Note: If no button is pressed within a period
of two minutes, the kitchen scale’s display
automatically shows the time.
Q
Using the digital timer
j Press the MODE / + button 5 until the
device enters the digital timer mode. This
comes after the alarm function.
j Press the SET / WEIGHT MODE button 3
to enter the settings mode. The seconds
display value flashes.
j You can use the MODE / + button 5 or the
Digital timer / UNIT / Alarm / - button 4 to
set the value.
j Press the SET / WEIGHT MODE button 3
to store the set value and move on to setting
the minute display value. The minute display
value flashes.
j You can use the MODE / + button 5 or the
Digital timer / UNIT / Alarm / - button 4 to
set the value.
j Press the SET / WEIGHT MODE button 3
to store the set value and leave the settings
mode.
j Press the Digital timer / UNIT / Alarm /
- button 4 to start the digital timer. The digital
timer indicator 21 appears in the display.
Note: While the digital timer continues to
run, you can switch the device to another
function by pressing the MODE / + button 5 .
The digital timer indicator 21 then continues
to appear in the display.
j You can switch off the digital timer by press-
ing the Digital timer / UNIT / Alarm /
- button 4 again. The digital timer indicator
21 disappears from the display.
j When the set time expires, an audible alarm
signal sounds for about one minute and the
previously set time appears on the display.
j No audible alarm signal sounds if the set
time is reached when the device is in the
weighing mode. Instead the digital timer
indicator 21 flashes in the display.
Note: If no button is pressed within a period
of two minutes, the kitchen scale’s display
automatically shows the time.
Q
Resetting the settings
j The reset button 11 can be found on the
back of the housing. Press this button to reset
all the settings to the default factory settings.
Q
Replacing the batteries
j When the batteries become weaker, the
battery charge state indicator 19 in the
display will light up.
j Replace the batteries as soon as the symbol
“ ” appears in the display. Weak or ex-
hausted batteries can affect the accuracy of
the measurement results.
j Open the battery compartment 8 on the
back of the scale.
j Remove the discharged batteries and dispose
of them properly in accordance with the ap-
plicable regulations (see section “Disposal”).
j Insert two new batteries type CR2032,
3 V into the battery compartment 8 .
Make sure you fit the batteries the right way
round (polarity). The correct polarity is
shown under the battery compartment 8 .
j Then close the battery compartment 8 .
75609 CB3_GB_DK.indd 10 7/5/2012 8:47:33 AM