Operation, Setting the signal type – Silvercrest Z31370A/Z31370B Benutzerhandbuch
Seite 15
GB/IE/CY 15
Operation
You can also manually enter synchronising mode by holding the
synchronising button
2
for approx. 3 seconds.
The signal indicator
1
on the receiver will light on.
Press the chime button
13
, the signal indicator
11
on the transmitter
will illuminate once.
The signal indicator
1
on the receiver will then blink. This is to indi-
cate the synchronisation is successful.
NOTE: The synchronisation mode can only last for approx. 2 minute. If
you cannot synchronise your transmitter and receiver, please enter syn-
chronising mode again.
NOTE: After the transmitter and receiver have been successfully
synchronised, wait for approx. 2 minutes until a visual signal appears.
The signal display
1
on the receiver goes out after 2 minutes, the
transmitter and receiver are synchronised.
Setting the signal type
The receiver can indicate the reception of a door signal either optically
or acoustically or both optically and acoustically.
Using the signal type selector button
5
, select whether the signal
is to be indicated optically or acoustically or both optically and
acoustically.