Unpack and set up, 5 protection against injury, 6 for the safety of your child – Silvercrest STV 45 C2 Benutzerhandbuch
Seite 8: 1 assemble appliance
6
• Never touch the appliance, the mains
cord or the mains plug with moist hands.
• Always pull the mains cord out by the
plug. Never pull it by the cord itself.
• Ensure that the mains cable is not kinked,
twisted or crushed.
• Ensure that the mains cable is not
damaged on sharp edges.
• Keep the mains cord away from hot
surfaces (such as stove eyes).
• If you are not using the appliance for a
prolonged period of time, remove the
plug from the wall socket. Only then is
the appliance completely free of current.
• You should avoid using extension cords.
This is only allowed under very
particular conditions:
• The extension cord has to be suited for
the appliance's amperage.
• The extension cord must not be
installed "loose": it must not be
possible to trip over it or within the
reach of children.
• The extension cord must not by any
means be damaged.
• No other devices other than this
appliance must be connected to the
mains socket, as otherwise
overloading of the power supply
network could occur (multiple sockets
are not allowed!).
• The appliance must not be operated
with an external time switch or separate
remote control system, such as a wireless
remote control socket.
4.5 Protection against injury
Warning! To avoid injury, please
observe the following information.
• Ensure that it is not possible for anyone
to trip over or to get caught up in or step
on the mainscable.
4.6 For the safety of your child
Warning! Children often cannot
assess dangers correctly and are
injured as a result. Please therefore
observe the following:
• Always take care to ensure the
appliance is kept out of the reach of
children at all times.
• Ensure that the packing foil does not
become a deadly trap for a child.
Packing foils are not toys.
5. Unpack and set up
5.1 Assemble appliance
Before the appliance can be started up,
stand 8 needs to be screwed on.
1. Take the appliance out of the
packaging.
2. Remove the transport packaging.
3. Check that the appliance has not
sustained any damage.
4. Put rear half of the stand 10 and front
half of the stand 11 together.
Note You can recognize rear half of the
stand 10 by the depression for power
supply cable 9.
5. Use screw ring 12 supplied to screw
stand 8 to the underside of the tower
fan.
RP103879 Tower-Ventilator LB6so Seite 6 Mittwoch, 1. Oktober 2014 11:26 11