Metz LCD-TV 20 TM 52 - Handbuch (Seite 57)

- 53 -
Volume Bar
It is displayed in the lower middle of the
screen. When a volume command is re-
ceived (pressing “
+” or “ -” by Re-
mote Control or Control panel at the top of
the TV) and no menu is active, it stays on the
screen for 3 seconds, after the last volume
command or until another command is re-
ceived in between.
AV Modes
By pressing the “AV“ button you can switch
your TV to AV modes (except being in Tele-
text). Pressing this button will consecutively
switch the TV in one of the optional AV
modes: AV-1, AV-2, AV-3, S-VIDEO, PC.
In order to quit the AV mode press the “TV”,
digit buttons or “P-” or “P+” .
Signal Out Of Range
When the PC input signal is not supported
by LCD-TFT TV, a message is displayed like
“Signal out of range” and screen is blanked.
PC MODE
Installation
• Power off both Computer and Display before
making any connections.
• The monitor comes with a 15-pin PC cable.
Connect end of the signal cable to the 15-
pin connector on the rear of the Computer.
$ÃQvÃHvvÃ9TˆiÃ8‚rp‡‚
• Tighten the screws of the Display cable until
the connectors are fastened securely (fin-
ger-tighten only).
• If you are using Windows operating system
running on a PC with a Microsoft Plug & Play
compatible video card, your system will se-
lect the appropriate timing for your monitor.
Switching from TV to PC
Press “ ” before (hold pressed) and then
SHIFT button together to swich directly PC
mode.
Main Menu in PC mode:
Enter the main menu by pressing the
“MENU” button on the remote control.
Sound Menu
In the main menu select “Sound” using “ ”
or “ ” button then enter the Sound menu
pressing “ ”, “ ” or “MODE” buttons.
The items in this menu are described at
Sound menu starting page 43.
6RXQG
Picture Menu
In the Main menu, select “Picture” using “ ”
or “ ” button, then enter the Picture menu
pressing “ ”, “ ” or “MODE” buttons.
All adjustment in this menu except Picture
Mode is identical to adjustment defined TV
picture menu starting on page 45. Picture