Zanussi ZWG6120P - Handbuch (Seite 15)

5
Delay Start
l e t s t i u t r a t S
é r é f f i d t r a p é D
3H 6H 9H
The start of the programme can be delayed by 9, 6 or 3 hours by means
of this button. The relevant light illuminates.
You must select this option after you have set the programme and before
you start the programme.
Select a delayed start:
• select the programme and the required options;
• select the delay start by pressing the button 5 ;
• press the button 6 :
– the appliance starts its hourly countdown.
– The programme will start after the selected delay has expired.
Cancelling the delayed start after having started the programme:
• set the appliance to PAUSE by pressing the button 6 ;
• press the button 5 once, the light relevant to the selected delay goes off;
• press the button 6 again to start the programme.
The DELAY START cannot be selected with the drain programme.
Important! The selected delay can be changed only after selecting the
washing programme again. The door will be locked throughout the delay
time. If you need to open the door, you must set the appliance to PAUSE
(by pressing the button 6 ) and then wait a few minutes. After you have
closed the door, press the button 6 again.
6
Start/Pause
e z u a P / t r a t S
e s u a P / t r a p é D
Start the programme by pressing the button 6
• To start the selected programme, press the button 6 , the correspond-
ing green pilot light stops flashing. The pilot light 7.1 illuminates to
indicate that the appliance starts operating and the door is locked. If
you have chosen a delayed start, the appliance will begin the countdown.
• To interrupt a programme which is running, press the button 6 : the
corresponding green pilot light starts flashing. It is possible
to change some options of a running programme before the pro-
gramme carries them out.
• To restart the programme from the point at which it was interrupted,
press the button 6 .
• After the programme has started the door is locked. If, for any reason,
you need to open the door , set firstly the appliance to PAUSE by press-
ing the button 6 . After a few minutes it will be possible to open the door.
If the door remains locked, this means that the appliance is already
heating or that the water level is too high. In any case, do not try to
force the door!
If you cannot open the door but you need to open it you have to
switch the appliance off by turning the selector dial to . After a few
minutes the door can be opened ( pay attention to the water level and
temperature! ). After closing the door, it is necessary to select the pro-
gramme and options again and to press the button 6 .
15