Champion – Clearaudio CHAMPION BASIC Benutzerhandbuch
Seite 18
Champion
Bedienungsanleitung
USER MANUAL
Seite/Page 18
© clearaudio electronic GmbH 2007
4. Speed calibration
Install the drive belt, first around the platter, then around the motor pulley. There are two diameters on
the motor pulley:
• smaller for 33 1/3 rpm
• larger for 45 rpm
To correctly adjust the belt tension, turn the motor around its axis. Proper tension will be achieved
through eccentric placement of the motor pulley or if you have enough space on your platform, just
change the distance between the motor and the turntable chassis. The belt tension is correct if the belt
can be deflected by approximately ¾inch by a finger.
5. SPECIAL INSTRUCTIONS
Please take the time to fill out the enclosed warranty card and return it to Clearaudio or your local
distributor / dealer. If you do not return this card within 14 days of purchase the guarantee
will only be for a period of two years from the date of purchase. During any transportation of
the turntable, always remove the platter and inverted bearing. If this is not done, DAMAGE COULD
OCCUR!
Please regularly check the mains leads of your motor assembly. If there is any damage to any wires or
the mains plug, have them replaced immediately by a qualified person (your dealer or distributor).
To clean the turntable, use only special acrylic cleaner, which is not alcohol based. Otherwise you
could damage the material (hair cracks and spots on the acrylic surface).
6. SERVICE
If any service or repair on all Clearaudio products is necessary, please contact your dealer / distributor
or contact Clearaudio directly. We will inform you about your nearest service location.
PLEASE RETAIN ALL ORIGINAL PACKAGING. You will need it if this unit has to be transported
and/or shipped.
Clearaudio electronic GmbH
Spardorfer Str 150
91054 Erlangen
Germany
Tel/Phon: +49-(0)1805/059595
www.clearaudio.de