Clearaudio TT2 (Tangential) - Handbuch (Seite 7)

TT 2
User manual / Bedienungsanleitung
Seite / Page 7
 clearaudio electronic GmbH 2014
Pic.8: To seize the screw
Pic.10: Correct position of the headshell
Pic.9: Turning the headshell back
Positioning shaft
Tighten the screw of the tonearm base as shown in
picture 6.
Before the next step please first remove all
counterweights from the headshell.
Slide the headshell through the proper drilling in the
carriage of the tonearm.
When sliding the headshell, turn the headshell
(as shown in pic. 8) so that the positioning shaft of the
headshell can pass the main rod of the tonearm.
After passing the first main rod, turn the headshell back
(as shown in pic. 9)
Pic.6: Tighten the screw of the VTA-assembly
Pic.7: Setting up the headshell
Pic.8: Turning the headshell
Distance between
diamond tip and
headshell locking
screw
is approx.
62 mm / 2.44 inch
Approx.
1.5 cm
(15 mm) /
0.59 inch