Ce statement, Fcc statement – DJI Phantom Quick Start Benutzerhandbuch
Seite 19

©2012-2013
DJI Innovations. All Rights Reserved.
19 |
Max Fluggeschwindigkeit
10 m/s
Diagonale Länge (Motorrotationspunkt zu Motorrotationspunkt)
350 mm
Gewicht
Gewicht (mit Batterie)
670 gr
800 gr
CE Statement
Due to the used enclosure material, the device shall only be connected to a USB Interface of version 2.0 or higher. The
connection to so called power USB is prohibited.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS.
Hereby, DJI Innovations Corporation declares that this device is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC.
FCC Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or
changes to this equipment. Such modifications or changes could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.