Gossen DIGISKY Part 2 Benutzerhandbuch
Seite 11
GOSSEN Foto- und Lichtmesstechnik GmbH
11
Changes are acknowledged
with the M key.
Measurements are stared
with the M key.
The flash function is
immediately displayed
along with the previously
measured values.
For additional settings press
the
key and
return to the radio menu.
3.1
The “All Units” Setting
All receivers (flash units) detected by the DIGISKY are listed.
All changes are accepted at all units.
Individual flash units included in the list can be changed.
3.2
The “Group 1 ... 4” Setting
All of the receivers detected by the DIGISKY which are assigned to the
group are listed (up to 6 units are listed).
All changes are accepted at all units which are assigned to the group.
Individual flash units included in the list can be changed.
If not all of the receivers are listed although they are switched on (please double check), start
the “Auto Scanning” function (see section 3.3.1, “Auto Scanning”, on page 13) or:
Flash units which do not transmit their ID codes to the Digisky have to be added manually (see
section 3.3.2, “Adding Devices Manually”, on page 13).
I
Save studiosets
to memory if you will use them frequently (see section 3.3.3, “Saving
Studiosets”, on page 14).
Initialization can be avoided in this way when you switch your Digisky on. In this case, only the
units/modules in the stored sets are detected and initialized.