Florabest FHE 550 A1 - Handbuch (Seite 16)

16
GB IE
Machine part Action
Before
every
use
After
Each
Use
Complete Machine Check the condition, replace damaged
parts if required

Accessible screws
and nuts
Retighten

Sprocket chain
wheel (18)
Check, replace if required

Saw chain (1) Check, regrind or replace if required 
Saw chain (1) Clean
(also oil after a longer period out of use)

Guide bar (2) Check

Guide bar (2) Clean
(also oil after a longer period out of use)

Oiltank (22) Check, fill up chain oil if required 
Maintenance Interval Table
Trouble shooting
Problem Possible cause Fault correction
Device does not
start
Mains voltage defective
House protection fuse activated
Check plug socket, cable, line and
plug, where appropriate, repair by
electrical specialist.
Check house protection fuse, see note
Defective On/Off switch (10)
Repair by customer service Worn carbon brushes
Defective motor
Inferior cutting
performance
Incorrectly mounted saw chain Mount saw chain correctly
Saw chain (1) blunt
Sharpen cutting teeth or place on
new chain
Chain tension insufficient Check chain tension
Saw runs with
difficulty, chain
(1) comes off
Chain tension insufficient Check chain tension
Chain (1) be-
comes hot,
smoke develop-
ment during saw-
ing, discoloration
of the rail
Too little chain oil
Check oil level and, where appropri-
ate, refill with chain oil,
check oil automatic system and,
where appropriate, clean oil outflow
duct ( D 17) or have repaired by
customer service
Check fine-tuning for lubrication
system (oil regulation button).