Sunpak PF20XD - Handbuch (Seite 3)

10
How to load cells
(1) Remove the cell cover. Load cells, being careful of their
polarity. Incorrect polarity may cause damage to SUNPAK.
* Use the following types
of cells for SUNPAK:
AAA alkaline
AAA oxyride
AAA NiCd
AAA NiMH
(2) Close the cell cover,
while pushing in the cells.
How to turn on the power
(1) Turn the ON/OFF dial to ON, and charging starts. Then
the TEST button lights to show that and charging will begin
for flash firing have been completed.
(2) To turn off the power, turn the ON/OFF dial to OFF.
Preparations for use
The synchronization mode switch is used to set the same
flash mode for your camera and SUNPAK.
Set the flash mode before turning on SUNPAK. Once
the flash mode is set, SUNPAK can be used without
resetting. Referring to the following illustration, set the
synchronization mode switch to the position corresponding
to your camera. Use a ballpoint pen, etc., to select a
position.
Hot shoe Pre-flash Non-pre-flash
If you are uncertain whether the flash mode for your camera
is pre-flash or non-pre-flash, set the switch to the pre-flash
position. If the flash mode for your camera is not pre-flash,
SUNPAK will not work in synchronism with your camera.
In this case, set the synchronism mode switch to the
non-pre-flash position.
Set the forcible-flash strobe mode on your camera. If your
camera uses red-eye reduction, cancel it.