Spektrum SPMAR7110 - Handbuch (Seite 11)

11
EN
Bracket adjusted for 50-size engine Bracket adjusted for 90-size engine
• Plug the servo leads and rpm sensor into the appropriate ports in the receiver.
• You are now ready to bind the system.
Note: In order for the system to operate, one remote receiver must be plugged into
receiver port B or R.
Connections
The throttle and gear channels have two outputs. Output 1 is unregulated and the
pack voltage is provided at this port. Throttle and Gear outputs 2 are regulated to
5.2 volts when a throttle servo and gyro are used that are not compatible with high
voltage. Most gyros require less than 6 volts.
Binding Telemetry with PowerSafe Receivers
Spektrum PowerSafe receivers like the AR9110, AR12110 and the AR7110 require
a special binding procedure when using telemetry modules.
1. Insert a bind plug in the bind port in the receiver.
2. Insert the telemetry modules’ Data port lead into any un-used channel in the
receiver. (If all channels are being used remove any servo lead from the receiver
to allow an open servo port to be accessed).