Eppendorf Thermoblocks - Handbuch (Seite 6)

6
Instructions for use
4.1.2 MTP exchangeable thermoblock
1. Insert the short screws in the MTP exchangeable thermoblock with the flat washers.
2. Secure the screws from below using the lock washers.
The lock washers prevent the screws from falling out of the bores if the exchangeable
thermoblock is not fixed on the unit.
3. Place the MTP thermoblock on the device in such a way that the spring plate is to the
front left.
4. Tighten the screws.
WARNING!
Warning! Risk of burns from hot surfaces.
The exchangeable thermoblock can be very hot after heating and cause
burns.
 Allow the heated exchangeable thermoblock to cool down completely
before removing the exchangeable thermoblock.
1. Place the exchangeable thermoblock (2)
on the thermosocket with the flat edge and
the writing facing the front.
2. Tighten the captive screws (1).
WARNING!
Caution! Melting of the MTP from excessive temperatures.
 Only heat the polystyrene MTP up to max. 70 °C.