Eppendorf 5418 R Centrifuge - Handbuch

Transporting, Installing, Transferring and Disposing of the Centrifuge 5418 R
1
Entwurf
Transporting, Installing, Transferring and Disposing of the Centrifuge 5418 R
Instructions for use
These instructions for use complement the operating manual for the Centrifuge 5418 R and do
not replace it. You should therefore also read the operating manual before using the centrifuge
for the first time. The current version of the operating manual can be found in the Internet at
www.eppendorf.com.
1 Transport
 Only transport the device in the original packaging.
 The centrifuge must always be transported by two people.
 Use a transport aid for transporting over longer distances.
2 Installation
The weight of the centrifuge is 22 kg. The centrifuge must always be transported by two people.
2.1 Open the carton and lift the device
2.2 Place device on a stable, horizontal and non-resonant lab bench.
1. Cut the adhesive tape.
2. Open all 4 flaps of the carton.
3. Remove accessories.
4. Reach your hands under the device and lift
the centrifuge from the carton with another
person.
 Remove front and back transport protection
pads.
 Remove the plastic sleeve
 Observe a minimum distance of 30 cm to
adjoining devices at the sides and from the
rear side to the wall.
 Install the device in a well-ventilated location
which is protected from direct sunlight to
prevent it from overheating.