Clearaudio TT3 (Tangential) - Handbuch (Seite 10)

TT 3
User manual / Bedienungsanleitung
Seite / Page 10
 clearaudio electronic GmbH 2014
Pic.16 a: Bubble level Pic.16 b: Adjustment of the tonearm`s tilt angle
Pic.15: Adjustment of the tonearm
The carbon headshell tube should be parallel to the surface of the record (without needle
protection and cartridge lifted down record!).
To ensure a stable function mode of the tonearm, please
tighten the screws on the side of the tonearm (allen
wrench wrench # 2; see pic. 15).
To
Please unlock the screws to change the height of the
tonearm
tonearm.
The tonearm angle can be adjusted with the screw in the tonearm base (see pic. 16 b).
The tonearm angle is correct adjusted, if the bubble level is centered.
Adjust the correct stylus pressure as instructed in the cartridge´s user manual.
To achieve the exact stylus pressure we recommend the use of the clearaudio digital stylus
pressure gauge “Weight Watcher” (Art.-#: AC 094; also available at www.analogshop.de).
4.3 Adjustment of the Azimuth (vertical needle-position in the groove).
Please be very careful by the following steps:
Lift your cartridge up (!)
Take a straight bar or rod (e.g. hex key wrench) which
can be placed on the top of the cartridge.
Place this piece on top of the headshell as shown in
the picture 17 and secure it with an piece of adhesive
tape.
a
b
a = b !
Pic.17. Adjustment of the Azimuth