Neff M83R42N2MC - Handbuch (Seite 4)

en
Ú Ins tallation ins tructions You must note the following
Electrical connection: Must only be carried out by a licensed
expert. Incorrect connection will invalidate the warranty.
Installation: Must only be carried out by a professional. The
fitter is liable for any damage.
Hob and cooker: Must only be from the same brand and have
the same combination feature.
Protection against accidental contact: Must be ensured
through the manner of installation.
Installation instructions: Must be observed for the cooker.
Work surface: Level, horizontal, stable.
Preparing the units - Figure 1
Fitting unit: Heat resistant to at least 90°C.
Cut-out: Minimum distance to the side walls: 70 mm.
After the cutting out work is complete, remove the shavings.
Cut surfaces: Seal with heat-resistant material.
Connecting the hob - Figs 2 and 3
The cooker must be connected to the mains, but switched off.
Put the hob down as shown in Fig. 2.
1. Screw the hob's
PE conductor (green/yellow) onto the cooker
earthing point < .
2. Plug the hotplate plug into the cooker - see Fig. 3. The colour
of the cable must correspond to the colour shown on the label.
The lug N on the plug must point to the left.
Fitting the hob - Fig. 4
Cables: Do not trap cables when fitting.
Push the hob in until it locks into place.
Insert the hob in the existing worktop cut-out with a depth of
500 mm - Figure 5
1. Mark the centre of the cut-out
2. Put the hob in place
3. Align the markings on the hob surround and cut-out
4. Press in the hob.
Removing the hob
Disconnect the appliance from the power supply.
Pull out the cooker a short distance. Unplug the cooking zone
plug. Finally, disconnect the PE conductor (green/yellow) from
the earthing screw.
Push out the hob from below.