Livarno Z30661A Z30661D - Handbuch (Seite 5)

5 GB/IE
Safety Information
J This device is not a toy and should not be
played with by children. Children are not able
to understand the dangers that can occur when
handling this device.
WarNINg! rISK OF FaTaL INJUrY!
During installation keep children away from the
area in which you are working. The scope of
supply includes a number of screws and other
small parts. These may prove lifethreatening if
swallowed or inhaled.
J Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited must
never be allowed to use the device without
supervision or instruction by a person responsible
for their safety. Children must never be allowed
to play with the device.
J CaUTION! DaNgEr OF EX-
PLOSION! Do not operate the lamp
in potentially explosive environments
in which there are inflam mable vapours, gases
or dusts.
J The light is not suitable for cool
beam halogen bulbs (reduces the
heat load in the light beam).
J This light is designed for use indoors
only, in dry and enclosed rooms.
J CaUTION! Only use LED bulbs with a GU 10
fitting and a maximum rated power of 4 watts.
Danger to life by electric shock
J Electrical installation must be performed by a
qualified electrician or a person authorised to
perform electrical installations.
J Every time before connecting the lamp to the
mains, check it and the mains lead for damage.
Never use your light if you find it is damaged in
any way.
J Before installation, remove the fuse for this circuit
or switch off the circuit breaker (0 setting) in
the fuse box.
J Make sure before installing the light that the
mains voltage at the place of installation
complies with the operating voltage of the light
(230 V ~) and that the wire cross-section of the
supply cable is not less than 1 mm 2 . Do not
install the light if this is not the case.
J Never let the lamp come into contact with
water or other liquids.
J Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing
can lead to a serious danger to life from
electric shock.
J Never point the LED beam at reflective surfaces,
people or animals. This could result in blindness
or irritation of the eyes. Even weak LED radiation
could lead to eye injuries.
avoiding fire hazards
and risk of injury
m CaUTION! rISK OF INJUrY! Check the
lamps and light immediately on unpacking for
signs of damage. Do not install the light if you
discover any damage. In the event of damage,
please contact the service office for replacement.
WarNINg! rISK OF ELECTrIC SHOCK!
rISK OF DaMagE TO PrOPErTY! rISK
OF INJUrY! Ensure that you do not strike
electrical cables, gas or water pipes when you
are drilling into the ceiling. If necessary, check the
ceiling using a suitable detector before you drill.
J
0.5 m
FIrE HazarD! Fit the light so that
it is at least 0.5 m away from the
material illuminated. Fire can result
from the development of too much heat.
CaUTION! rISK OF BUrNS! Make sure that
the light is switched off and has cooled down for
10 min. before you touch it. Lamps can become
very hot.
J Note that the LEDs are not dimmable.
Correct procedure
J Check before fastening the light to the ceiling
whether the ceiling is suitable for supporting
the light. If necessary seek advice from your local
DIY supplier or a construction professional.