AUDIOLINE Watch&Care V120 - Handbuch (Seite 21)

7
GB
Use these buttons to switch the night light on the transmitter on or off.
Switching the vibration alarm on/off
Press the button four times.
This icon appears in the display.
Use these buttons to switch the vibration alarm on or off.
When the vibration alarm is activated, the receiver vibrates when sounds in the room
being monitored are so loud that the red Sound Level LEDs are activated.
Adjusting the VOX sensitivity
(VOX: Voice Operated Transmission = Sound detection)
The VOX function (sound detection) causes the system to start transmitting automatically from the
transmitter to the receiver immediately a voice or sound is detected.
Press the button five times.
This icon appears in the display.
Use these buttons to set VOX to OFF or adjust the sensitivity to one of 5 levels. When
one of the five levels has been set, the VOX icon lights up in the display. The display
goes out after 10 seconds. The display is reactivated when a sound is detected or a but-
ton on the receiver is pressed.
If the receiver is operated by battery power that the display will switch off after 10 seconds of
inactivity, but will switch back on if triggered by the vox detector in the transmitter.
However if the receiver is placed on the charger, or VOX is set to OFF, the display will remain on all
the time.
Setting the zoom
You can zoom in on the image.
Press the button six times.
A magnifying glass icon appears on the display.
Use these buttons to set the zoom.
Selecting a lullaby
Switch on: press the button briefly.
This icon appears in the display.
Use the button to select one of the 5 lullabies (1-5).
Operating the Receiver
BA Audioline 4 250711 991272 Watch&Care V120_V1_0_DE_GB_191212_Serie_Layout 1 19.12.12 15:51 Seite 7