Clearaudio TQ-I (Tangential) - Handbuch (Seite 20)

clearaudio-TQ-I
User manual / Bedienungsanleitung
Seite/Page 20  clearaudio electronic GmbH 2015
3. clearaudio TQ-I placement
It is easier for you to place the tonearm, if the two rods of the base are in vertical position. To achieve
this, please pull out the small pivot on the side of the base and bring the two rods in the exspected
position. Now you can bring the tonearm with its two precise drills onto the two rods of the base. Do
this until the distance between the lower side of the tonearm and the upper side of the tonearm base
is about 20mm (this distance depends on the turntable-model you are using).
Lock the two screws on the side of the tonearm to fix the position of the tonearm with the hex key
wrench (#2).
The now following adjustment requires an already mounted cartridge on the headshell. Follow the
instructions in the users manual of the cartridge manufacture.
Before mounting
the tonearm you
must unscrew the
red marked screw!
After mounting the
tonearm, the screw
must be screwed
tight, ore else the
height adjustment
didn’t work! !