Clearaudio TQ-I (Tangential) - Handbuch (Seite 22)

clearaudio-TQ-I
User manual / Bedienungsanleitung
Seite/Page 22  clearaudio electronic GmbH 2015
4. clearaudio TQ-I adjustment
For this adjustment now take an old, used vinyl. This LP should be flat and not too thick. Instead of a
LP you can also use the delivered linear tracking gauge, which is nearly as thick as an LP.
Adjust little stylus pressure, while sliding the counterweight(s) in the direction of the cartridge. The
exact pressure will be adjusted later. Lift the cartridge with the cueing lever down on the LP (or the
linear tracking gauge). To achieve the right height of the cartridge you have to loosen the two screws
in the side of the tonearm, so that you can move the tonearm up and down on the two rods. The two
supporter screws (the tonearm rests on the supporter screws) had to be adjusted in the same
direction, that after changing the height, the bubble of the mounted level gauge in the tonearm will be
positioned as shown in the left picture. The headshell rod should be parallel to the surface of the LP. If
so, you can fix the tonearm in this position with the two screws again. You can lock the supporter
screws with the nuts.