Livarno 2764-062L or 2788-068L or 2787-062L - Handbuch (Seite 15)

15 GB
Introduction Introduction / Safety
15 Pin (2788-068L and 2787-062L)
16 Protective ring (2788-068L and 2787-062L)
17 Light glass (2788-068L and 2787-062L)
18 Light bulb
19 Spacer (2787-062L)
20 Washer (2787-062L)
21 Washer (2787-062L)
22 Locating screw (2787-062L)
23 Chrome decorative ring (2787-062L)
24 Glass plate (2787-062L)
25 Screw (2787-062L)
Technical Data
Item no.: 2764-062L or 2788-068L
or 2787-062L
Operating voltage: 230 V ∼, 50 Hz
Light bulb:
GU10 (2787-062L), max.
5 W, 220–240 V~ 50 Hz
E14 (2788-068L,
2787-062L), max. 5.5 W,
220–240 V~ 50 Hz
LED (not replaceable)
max. 5 W (2764–062L),
230 V ~ 50 Hz
Rated output max.: 6 x 5 W (2764-062L)
6 x 5.5 W (2788-068L)
4 x 5.5 W (E14) + 2 x 5 W
(GU10) (2787-062L)
Safety
Safety notices
Damage due to failure to comply with these operat-
ing instructions will invalidate the guarantee! We
assume no liability for consequential damage! We
assume no liability for material damage or per-
sonal injury due to improper handling or failure to
comply with the safety instructions!
Avoid the risk of fatal injury
from electric shock
Ensure that a qualified electrician, or a person
trained to carry out electrical installations,
performs the electrical installation.
Always check the light, power supply, and
mains cable for damage before plugging it in.
Never use the light if it shows any signs of
damage.
CAUTION! A damaged mains cable indi-
cates a life-threatening danger due to electric
shock. In the event of damage, repairs or other
problems with the light please contact the
service centre or a qualified electrician.
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse box.
Prior to installation verify the mains voltage on
site corresponds with the operating voltage
required for the light (230 V∼).
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the light on a wet or conductive
substrate!
Prevent fire and
injury hazards
RISK OF INJURY! Check each lamp and
lamp glass for damage immediately after un-
packing.
Do not mount the light with defective lamps
and/or lamp lenses. In this case contact the
service centre for a replacement.
RISK OF BURNS! Ensure that the
luminaire has been switched off and
has cooled before touching it, to
avoid burn injuries. Lamps develop a lot of
heat in the area of the lamp head.
Allow the lamp to cool off completely.