What to do if – Zanussi ZOS 35802 XD Benutzerhandbuch

Seite 21

Advertising
background image

Make sure that you install the internal glass
panel in the seats correctly. Refer to the illustra-
tion.

What to do if…

Warning! Refer to "Safety information"
chapter.

Problem

Possible cause

Remedy

The oven does not heat up.

The appliance is deactivated.

Activate the appliance.

The oven does not heat up.

The clock is not set.

Set the clock.

The oven does not heat up.

The necessary settings are not
set.

Make sure that the settings are
correct.

The oven does not heat up.

The fuse in the fuse box is re-
leased.

Do a check of the fuse. If the fuse
is released more than one time,
contact a qualified electrician.

The oven lamp does not operate.

The oven lamp is defective.

Replace the oven lamp.

There is water inside the oven.

There is too much water in the
tank.

Deactivate the oven and wipe the
water with a cloth or sponge.

The indicator "Tank Full"

is off.

There is no enough water in the
tank.

Fill the tank with water until the in-
dicator comes on. If water starts to
come out inside the oven, and the
indicator is still off, contact a quali-
fied service engineer.

The indicator "Tank Empty"

is

on.

There is no water in the tank.

Fill the tank. If the indicator is still
on, contact a qualified service en-
gineer.

The steam cooking does not work.

There is no water in the tank.

Fill the water tank.

The steam cooking does not work.

Lime obstructs the hole.

Check the steam inlet opening.
Remove the lime.

It takes more than three minutes to
empty the water tank or the water
leaks from the steam inlet opening.

There are lime deposits in the
oven.

Clean the water tank. Refer to
"Cleaning the water tank".

The display shows 12.00.

There was a power cut.

Set the clock.

Steam and condensation settle on
the food and in the oven.

You left the dish in the oven for
too long.

Do not keep the dishes in the oven
for longer than 15 - 20 minutes af-
ter the cooking ends.

If you cannot find a solution to the problem
yourself, contact your dealer or the service cen-
tre.

The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity.

21

www.zanussi.com

Advertising