ABUS CASA10010 Benutzerhandbuch
Seite 33
33
English
Now the recorder is setup for the processing of the alarm signal from IP alarm module “Zone 2” (magnetic
contact).
The alarm recording on the recorder will only start if the schedule is active (remote control)
and an alarm signal is applied to the recorder (magnetic contact)
7. Example 2: IP-alarmmodule + PIR-IP Networkcamera
Make sure that a network connection between PIR IP network camera, router and IP alarm module is
available. Please note following settings from PIR network camera:
o
IP-address (e.g.: 192.168.0.5)
o
Username (e.g.: root)
o
Password (e.g.: root)
o
http-port (e.g.: 80)
7.1 Setting up the PIR IP network camera in the IP alarm module
Open the configuration interface of the IP alarm module by entering the IP address in your browser. Open
the “Device information” and press the button “TVIP41550”.
Entrance
Painting