AUDIOLINE TEL 19 - Handbuch (Seite 19)

- Commissioning -
19
3 Commissioning
3.1 Safety information
NOTE! Before commissioning, it is essential that you read the general information at the
beginning of this manual.
3.2 Check contents of pack
The following items are supplied:
one telephone base
one telephone receiver
one telephone connection cable one spiral cable
one desk adapter one Operating Manual
3.3 Connecting the telephone receiver
After unpacking your telephone, you must first connect the telephone receiver to the base unit.
First take the short end of the spiral cable and plug it into the socket at the bottom of the
receiver. Turn the telephone over and plug the long end of the siral cable into the socket
marked HANDSET. Feed the cable through the cable channel to the outside.
3.4 Connecting the telephone
Connect the telephone cable supplied to the telephone socket and the telephone jack LINE on
the underside of the telephone. Then feed the cable out of the telephone housing either
upwards or downwards through the cable guide. Clip the cable firmly in the cable channel. The
telephone works using the tone dialling system.
3.5 Private exchanges - Setting up for T-NET
You can use the “R” signal button on your telephone on private exchanges and when using
DEUTSCHE TELEKOM’s T-Net functions. If you use neither a private exchange or the T-NET-
functions of the DEUTSCHE TELEKOM, no adjustments must be made here.
Private exchanges
If you have connected your telephone to a private exchange, you can use all the facilities such
as call transfer, automatic recall, etc. The “R” signal button gives you access to these facilities.
The FLASH time “100ms” will be required on a private exchange. To make this setting, move
the slide switch on the underside to the “100ms” position. You can find out from the dealer
from whom the equipment was purchased whether your telephone will work on your private
exchange without any problems and which other facilities you will have access to.
T-NET functions
Your telephone supports the most important DEUTSCHE TELEKOM added value services
(e.g. brokering, call waiting, three-way conferencing, etc.). Please contact DEUTSCHE
TELEKOM to gain access to these functions (some of which are subject to charge). When
using T-NET functions, move the slide switch on the underside to the “300ms” position.