AUDIOLINE TEL 19 - Handbuch (Seite 25)

- Using T-NET / Private exchanges -
25
6 Using T-NET / Private exchanges
You can use the “R” signal button on your telephone on private exchanges and when using
DEUTSCHE TELEKOM’s T-Net functions.
6.1 “R” Button on private exchanges
If you have connected your telephone to a private exchange, you can use all the facilities such
as call transfer, automatic recall, etc. The “R” signal button gives you access to these facilities.
The FLASH time “100ms” will be required on a private exchange. For this purpose, set the
“FLASH” switch to the “100ms” setting. You can find out from the dealer from whom the
equipment was purchased whether your telephone will work on your private exchange without
any problems and what further facilities you will receive from this.
6.2 “R” Button and the DEUTSCHE TELEKOM T-NET functions
Your telephone supports the most important DEUTSCHE TELEKOM added value functions
(e.g. brokering, call waiting, three-way conference, etc.). The T-NET works using the "FLASH
300ms" setting. For this purpose, set the “FLASH” switch to the “300ms” setting. Please
contact DEUTSCHE TELEKOM to gain access to the T-NET functions (some of which are
subject to charge).
6.3 Dialling and storing telephone numbers when using on private
exchanges
Note! The pause function between the code for the outside line (usually 0 or 9) and the
dialling tone described in this chapter is only necessary on older private exchanges.
With some private exchanges, there is a short pause between the code for the outside line
(usually 0 or 9) and the dialling tone. This pause can be entered when dialling manually and
when dialling from the phone book so that the following numbers are not dialled too quickly.
Entering the pause when dialling manually
Press the redial button
once between the code for the outside line and the actual
telephone number. After an outside line has been obtained, you telephone will wait for 3
seconds before dialling the actual telephone number.
Storing the pause with the number
Simply press the redial button
after the code for the outside line and before the actual
telephone number when storing the number. When dialling from the phone book, a pause of
three seconds will then be automatically inserted after the code for the outside line.