Silvercrest SKM 350 A1 - Handbuch (Seite 11)

9 GB
Remove food
NOTE: do not store foodstuffs in the
bowl11 or in contact with other product
parts for longer than 24 hours. This also ap-
plies to storage in the refrigerator.
1. Disconnect the mains plug14 from the
wall socket.
2. Turn the bowl  11 anti-clockwise, until
the symbol 16 points to the bottom
marking on the bowl12.
3. Hold the bowl  11 tightly. Turn the lid3
anti-clockwise, until the symbol 2
points to the top marking on the
bowl10. Remove the lid.
4. Carefully remove the insert holder6 with
attached slicing insert4 / grating disk5
or the drive axle9 with the dough
blade7 / the blade insert8.
5. Empty the bowl  11. Remove the food,
e.g. using a spatula.
6. Clean the device as soon as possible af-
ter use.
8. Cleaning
Clean the device prior to its first use!
DANGER! Risk of electric
shock!
• Pull the mains plug14 out the wall socket
before cleaning the food processor.
• The motor block15, the power cable
and the mains plug14 must not be im-
mersed in water or any other liquids.
DANGER! Risk of injury from
cutting!
When washing manually, the water should
be sufficiently clear that you can see the
blades4,5 and8 easily.
WARNING! Risk of material damage!
Do not use any astringent or abrasive clean-
ing agents.
Dismantling the device
1. Pull out the mains plug14.
2. Turn the bowl11 anti-clockwise, until
the symbol 16 points to the bottom
marking on the bowl12.
3. Hold the bowl11 tightly. Turn the lid3
anti-clockwise, until the symbol 2
points to the top marking on the
bowl10. Remove the lid.
4. Carefully remove the dough blade7,
the blade insert8 or the insert holder6
with attached slicing insert4 / grating
disk5. Remove the drive axle9.
5. Figure F: turn the insert holder6
around and hold it over a washable,
scratch-proof surface. Press the extending
edges of the slicing insert4 / grating
disk5 inwards and press it out.
How to clean properly
1. If necessary, wipe down the motor
block15 and the power cable14 with
a damp cloth. Ensure that the motor
block15 is completely dry before the
next time it is used.
2. All parts except for the motor block15
are dishwasher-safe up to 70 °C.
3. Allow all parts to dry completely before
you put them away or use the device
again.
Some cleaning tips
• Clean the device as soon as possible af-
ter use in order to prevent food rem-
nants from drying on.
• After processing very salty or acidic
foodstuffs, the dough blade7 / blade
insert8, the insert holder6 and the slic-
ing insert4 / grating disk5 should be
washed thoroughly and right away.
__RP96282_B6.book Seite 9 Dienstag, 14. Januar 2014 9:20 09