Silvercrest SKM 350 A1 - Handbuch (Seite 8)

6 GB
• Do not operate the device when it is
empty, as this causes the motor to over-
heat and may result in it being dam-
aged.
• Only use the original accessories.
• Do not use any astringent or abrasive
cleaning agents.
• The device is equipped with non-slip
synthetic suction feet. As furniture is
coated with a wide array of varnishes
and synthetics, and is also treated with
different care products, it cannot be fully
ruled out that some of these materials
contain ingredients that could attack
and soften the non-slip plastic bases. If
necessary, place a non-slip mat under
the device.
NOTE: do not store foodstuffs in the
bowl11 or in contact with other product
parts for longer than 24 hours. This also ap-
plies to storage in the refrigerator.
4. Items supplied
1 Motor block15
1 Bowl11
1 Drive axle9
1 Lid3
1 Food pusher for food chute1
1 Blade insert8
1 Dough blade7
1 Insert holder6
1 Slicing insert4
1 Grating disk5
1 Set of operating instructions
5. How to use
• Remove all packing material.
• Check to ensure that all parts are pre-
sent and undamaged.
• Clean the device prior to its first
use ! (see “Cleaning” on page 9)
6. Installation
DANGER! Risk of injury from
cutting!
• The blade insert8, the grating disk5
and slicing insert4 are sharp. Handle
with care.
• Only plug the mains plug14 into the
wall socket after the food processor has
been completely assembled.
NOTE: the device is equipped with a safe-
ty switch. The bowl11 can only be
locked with a closed lid3 and can only be
put into operation once it's locked.
1. Figure A: place the bowl11 on the mo-
tor block15. The symbol 16 points to
the bottom marking on the bowl12. Do
not turn the bowl.
2. Place the drive axle9 in the bowl.
3. Figure E: if required, place the slicing
insert4 / grating disk5 into the insert
holder6.
4. Place the dough blade7, the blade in-
sert8 or the insert holder6 with at-
tached slicing insert4 / grating disk5
on the drive axle9.
5. Dough blade7 / Blade insert8: Fill the
prepared foodstuffs into the bowl11,
as desired.
6. Figure A+B: place the lid3 on the
bowl11. The symbol 2 points to the
top marking on the bowl10.
7. Figure B+C: turn the lid3 in a clock-
wise direction as far as it will go, until
the symbol 2 points to the top mark-
ing on the bowl10.
__RP96282_B6.book Seite 6 Dienstag, 14. Januar 2014 9:20 09