AEG KS7415001M - Handbuch (Seite 8)

8 Basic Settings
BASIC SETTINGS
Initial Settings
After your steam oven is first plugged in or after a power failure, the clock
display will flash to indicate that the time shown is not correct.
The oven will not operate until the clock and the water hardness are set.
To set the clock and the water hardness parameter value proceed as
described in the following chapters.
Setting the clock
1 2 3 4 5 6
12 30 188
To set the clock, proceed as follows:
• Select the Clock Symbol with the Parameter selection keys (not
necessary if your oven is first plugged in or after a power failure). The
hours start blinking.
• Set the hours with “+” and “-“keys .
• Confirm the selection with the Confirmation key .The minutes start
blinking.
• Set the minutes with the “+” and “-“keys .
• Confirm the selection with the Confirmation key .
Hiding/Displaying the Clock
• Select the Clock Symbol with the Parameter selection keys . The hours
start blinking.
• Press the Confirmation key and the Cancel/Safety Block Key at the
same (make sure that you press first the confirmation key).
To show the clock again, repeat the described procedure again.
6 1
3
1
4
1
4
3