Detaching and refitting the rails, Detaching the rails, Lift up the front of the rail – Bosch HSE720120 weiß Elektro-Standherd 60 cm mit Email-Mulde Benutzerhandbuch

Seite 35: And unhook it (figure a), Then pull the whole rail forward, And remove it (fig. b), Refitting the rails, And then hook it into the front socket (figure b), Detaching and attaching the oven door, Risk of injury

Advertising

Detaching and refitting the rails

The rails can be removed for cleaning. The oven must have

cooled down.

Detaching the rails

Lift up the front of the rail

and unhook it (figure A).

Then pull the whole rail forward

and remove it (Fig. B).

Clean the rails with cleaning agent and a sponge. For stubborn

deposits of dirt, use a brush.

Refitting the rails

First insert the rail into the rear socket, press it to the back

slightly (figure A),

and then hook it into the front socket (figure B).

The rails fit both the left and right sides. Ensure that, as shown

in figure B, levels 1 and 2 are below and levels 3, 4 and 5 are

above.

Detaching and attaching the oven door

For cleaning purposes and to remove the door panels, you can

detach the oven door.
The oven door hinges each have a locking lever. When the

locking levers are closed (figure A), the oven door is secured in

place. It cannot be detached. When the locking levers are open

in order to detach the oven door (Fig. B), the hinges are locked.

They cannot snap shut.

Risk of injury!

Whenever the hinges are not locked, they snap shut with great
force. Ensure that the locking levers are always fully closed or,
when detaching the oven door, fully open.

Detaching the door

Open the oven door fully.

Fold up the two locking levers on the left and right (figure A).

Close the oven door as far as the limit stop. With both hands,

grip the door on the left and right-hand sides. Close the door

a little further and pull it out (figure B).

Attaching the door
Reattach the oven door in the reverse sequence to removal.

When attaching the oven door, ensure that both hinges are

inserted straight into the opening (figure A).

The notch on the hinge must engage on both sides (figure B).

Fold back both locking levers (figure C). Close the oven

door.

Risk of injury!

If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the aftersales service.

Advertising