Removing and installing the door panels, Removal, Lift the top panel up and pull it out (fig. b) – Bosch HSE720120 weiß Elektro-Standherd 60 cm mit Email-Mulde Benutzerhandbuch

Seite 36: Lift the panel up and pull it out (fig. c), Risk of injury, Installation, Put the cover back in place and press on it, Attach the oven door, Troubleshooting, Malfunction table

Advertising
background image

36

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the

oven door.

Removal

1.

Detach the oven door and lay it on a cloth with the handle

facing down.

2.

Pull off the cover at the top of the oven door. Press in the

tabs on the left and right using your fingers (fig. A).

3.

Lift the top panel up and pull it out (fig. B).

4.

Lift the panel up and pull it out (fig. C).

Clean the panels with glass cleaner and a soft cloth.

:

Risk of injury!

Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.

Installation
During installation, make sure that the lettering "top right" is

upside down at the bottom left.

1.

Insert the panel at an angle towards the back (fig. A).

2.

Insert the top panel at an angle towards the back into the

brackets. The smooth surface must face outwards. (fig. B).

3.

Put the cover back in place and press on it.

4.

Attach the oven door.

Do not use the oven again until the panels have been

correctly installed.

Troubleshooting

Malfunctions often have simple explanations. Refer to the table

before calling the after-sales service as you may be able to

remedy the fault yourself.

Malfunction table

If a dish doesn't turn out as well as you had hoped, refer to the

section Tested for you in our cooking studio, where you will

find plenty of cooking tips and tricks.

:

Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced. Heat-

resistant, 40 watt spare bulbs can be obtained from our after-

sales service or a specialist retailer. Only use these bulbs.

:

Risk of electric shock!

Switch off the circuit breaker in the fuse box.

1.

Place a tea towel in the oven when it is cold to prevent

damage.

2.

Unscrew the glass cover by turning it anti-clockwise.

3.

Replace the bulb with one of the same type.

4.

Screw the glass cover back in.

5.

Remove the tea towel and switch on the circuit breaker.

Glass cover

You must replace a damaged glass cover. Suitable glass

covers may be obtained from the after-sales service. Please

specify the E number and FD number of your appliance.

%

$

&

%

$

Problem

Possible cause Remedy/information

The oven does

not work.

The circuit

breaker is

defective.

Look in the fuse box and

check that the circuit

breaker is in working order.

Power cut

Check whether the kitchen

light or other kitchen appli-

ances are working.

The oven does

not heat up.

There is dust on

the contacts.

Turn the control knobs back

and forth several times.

Advertising