Florabest FBM 575 B1 - Handbuch (Seite 36)

36
GB
Installing the Mulch Kit
The grass collection box must be
removed before using the mulch kit
(see “Installing the Grass Collection
Box”)
Fixing the Mulch Kit:
1. Lift the impact protection (7).
2. Remove the grass collection box
( 22) if it is installed.
3. Push down the button (28a) on
the mulch kit and plug in the
mulch kit (28). The button clicks
into place.
Removing the Mulch Kit:
4. Lift the impact protection (7).
5. Push down the button (28a) and
remove the mulch kit (28).
Filling with Engine Oil and
Checking the Oil Level
Place the equipment on a level
base.
1. Unscrew the oil filler cap and
dipstick (9) and pour oil into the
tank. The oil tank holds 0.47 l
oil. Use brand oil (e.g. SAE 30).
2. To check the oil level, wipe the
dipstick (9) on a clean cloth
and replace it in the tank until it
stops.
3. After pulling it out, read off
the oil level on the dipstick.
The oil level should be in
the marked area between
the minimum and maximum
marks.
4. Wipe off any spilt oil and
close the oil filler cap (9).
Check the oil level every time be-
fore mowing and add oil when the
lower marking point is reached.
Filling with Petrol
Warning! Petrol is flammable and
hazardous to health:
- Keep petrol in containers intended for
this purpose;
- Only refuel outdoors and never with
the engine running or when the ma-
chine is hot;
- Open the filler cap carefully to allow
excess pressure to escape;
- Do not smoke whilst refuelling;
- Avoid skin contact and inhalation of
the fumes;
- Remove spilt petrol;
- Keep petrol away from sparks, open
flames and other ignition sources;
- Dispose of leftover petrol in an environ-
mentally friendly way (see “Disposal /
Environmental Protection”).
- Do not use petrol/oil mixtures;
- Use normal or super unleaded
petrol;
- Only use clean, fresh petrol;
- Do not store petrol for longer
than one month, as its quality
deteriorates.
1. Unscrew the filler cap ( 11) and
pour in the petrol to the lower edge of
the filler. Do not fill the tank entirely, to
allow the petrol room to expand.
2. Wipe away petrol residues around the
filler cap and close the filler cap.