Philips VR702 - Handbuch (Seite 7)

Rear side of the video recorder:
nr
(ïï)
+m-
EXTERNAL1
EXTERNAL 2
MOD I/O
SIG
Aerial input socket
Aerial output socket
Channel control
AV-Euroconnector 1 (21-pin scart socket)
AV-Euroconnector 2 (21-pin scart socket)
Mains socket
MOD selector (modulator on = I ), fitted in some sets only
Attenuator switch
AUDIO R(D)
AUDIO L(G)
AUDIO R(D)
AUDIO L(G) -©
■©
G-
G»
Audio input Right socket
Audio input Left socket
Audio output Right socket
Audio output Left socket
With suitable TV sets the following functions are available (set the TVA^CR switch to ‘ TV ’):
IQ
■b:d
Personal preference button
TV volume up + (independent of TV / VCR switch position)
TV volume down - (independent of TV / VCR switch position)
Note ; On some teletext TV sets it is also possible to use the TXT-buttons marked in yellow.
Safety instructions
The manufacturer cannot be held responsible for damage which is
incurred by not using the video recorder in compliance with
the national guarantee conditions, safety instructions or pre­
cautions.
• First check if your supply voltage is the same as that written on
the type plate at the rear of the video recorder.
• Caution I Do not open the casing, risk of electric shock.
No user serviceable parts are to be found inside.
If the video recorder is connected to the mains there are still parts
of it in operation. To switch off the video recorder completely you
must disconnect it from the mains.
• Ensure that air can circulate freely through the ventilation
openings of the video recorder.
Do not place the video recorder on soft surfaces (carpets, etc.).
• Do not place the video recorder close to a source of heat
(radiator, etc.)
• Do not expose this video recorder to rain or moisture.
Ensure that no objects or fluids pass through the ventilation ope­
nings. If liquid is spilt into the video recorder, disconnect the video­
recorder from the mains and consult a qualified service technician.
Precautions
• Before connecting the video recorder to the mains, it should be
allowed to acclimatise for at least three hours after unpacking.
Do not use your video recorder immediately after moving it from a
cold to a warm location or vice versa, after heating a cold room or
under conditions of high humidity.
• Ensure that there is a vertical distance of at least 20 cm between
the video recorder and the TV set.
• Do not place the video recorder near appliances generating
strong magnetic fields (e.g.motors, loud speakers and trans­
formers).
• Do not use the video recorder in dusty places or where it may be
subject to vibration.
• During heavy thunderstorms we recommend disconnection of
the mains supply and of the aerial Hr" •
• Do not put your fingers or insert objects into the cassette loading
slot, as this might cause injury and/or damage to the mechanism.
Take special care with children.
• If you transport your video recorder, be sure to remove the video
cassette and avoid sudden or violent jolts.