Festo Мини-каретка SLT - Handbuch (Seite 25)

Eliminating faults
Fault Possible cause Remedy
Uneven movement
of moving mass - Restrictors incorrectly inserted
- Running surfaces dirty - Check restrictor function (supply or exhaust restriction)
- Clean running surfaces
Hard knocking in
end position Speed too high Reduce speed
- No cushioning or cushioning not
sufficent
- No air cushion
- Shock absorber defective
(only SLT-...-CC-B)
- Readjust shock absorber (see "Commissioning" - Preparation)
- Simultaneous pressurization of both compressed air ports with
exhausting of one side
- Replace shock absorber (see "Dismantling and Repairs")
Work load too large Reduce work load
Slide in start position
despite pressurization Fault in tubing Check blind plug and tubing
Reduced flow due to angled connectors Avoid angled connectors
Slide speed too low - Pressurization cross section too small
- Restrictors incorrectly set Check pressurization cross section and restrictor setting
Fig. 31
0608f D/GB 25