Spektrum SPM2800US DX10t - Handbuch (Seite 25)

25 SPEKTRUM DX10t • RADIO INSTRUCTION MANUAL
EN
11 PARAMETER PROGRAMMING THE FUNCTIONS OF A SAILPLANE MODEL IN
THE FUNCTION LIST
Servo setup with Submenu
Travel
Sub-Trim
Reverse
Speed Absolute Travel
Balance
Please refer to wing-type model programming for
instructions.
11-2 Dual Rate and Exponential
Settings can be done for Aileron, Elevator and Rudder.
Dual Rate and Expo will be shown in percentages
and switches are free to assign. Graphic information
of programmed values is shown on the left side of the
display.
11-3 Throttle Cut
The Throttle Cut function allows you to shut an engine
off with all assigned switches and tip switches on sticks
except: Pot1, Pot2, Pot3 and Pot 4.
In the Throttle menu, you can program the Gas Position,
assign it to a switch and set a delay up to 5 seconds.
Release the programmed throttle cut switch to resume
normal throttle operations.
11-4 Throttle Curve
Please refer to wing-type model programming for
instructions.
11-5 Mixes
Depending on the wing type you selected in the Function
List, different mixes are available.
Aileron to Rudder
Aileron to Flap Position
Elevator to Flap
Flap to Elevator
This is for wing type 2 Aileron , 2 Flaps
On some wing types some mixes are not active and
cannot be selected. Mixing is shown in percentages.
There are 6 optional programmable mixes that are
available.
11-6- Camber Presets
This menu is active when Flaps are selected at wing type.
Adjust the numerical values for left and right aileron
and left and right flap. Do the same for the elevator.
Optionally, adjust the speed from 0 – 30 seconds.
11- 7 Camber System
In this menu, you adjust the values for Spoilers and
Aileron from -100 and +100.