Metrohm tiamo 1.2 Manual - Handbuch (Seite 299)

Subwindow Curves 273
Parameters for the graphical presentation of the curves on the y1 axis (left-hand y
axis).
Quantity
Command-dependent selection
Selection of the quantity to be shown on the y1 axis.
Label
50 characters, [ auto ]
Freely definable axis labeling for the y1 axis. With auto the label from the
field Quantity will be used.
Scaling
Start value
1 E-8 ... [ 0.0 ] ... 1 E+8
Initial value for scaling the y1 axis.
End value
1 E-8 ... [ 1000.0 ] ... 1 E+8
Final value for scaling the y1 axis.
Curve
Curve color
Color selection, [ pink ]
Selection of the color for the curve line.
Symbol
Symbol selection, [ off ]
Selection of the symbol for the display of the individual measuring points.
With
off the individual measuring points are not shown.
Note
For curves with more than 100 measuring points, the individual measuring points
will not be shown any more, even if a symbol has been selected.
Symbol color
Color selection, [ pink ]
Selection of the color for the measuring point symbol.
Smoothing
on, [ off ]
Switches curve smoothing on/off. The smoothed curve will be shown as
dotted line.
Smoothing factor x axis
[ 0.01] ... 1000
Factor for smoothing on the x axis.
Smoothing factor y axis
[ 0.01] ... 1000
Factor for smoothing on the y axis.
Show with original curve
on, [ off ]
If this option is enabled then the original curve (solid line) will be shown in
addition to the smoothed curve (dotted line, same color).