Metrohm tiamo 1.2 Manual - Handbuch (Seite 411)

Commands 385
Control parameters
The Control parameters can be set for each endpoint separately.
Command name
25 characters, [ SET pH # ]
Name of the command.
Endpoint 1
EP1 at pH
-20.000 ... 20.000, [ off ] (Titrando),
-20.00 ... 20.00, [ off ] (Titrino)
Measured value for the first endpoint.
Titration rate
Titration rate
Three predefined sets of parameters can be selected for the titration rate:
slow , optimal and fast . For these sets the parameters for the Control are not
displayed. In order to edit these parameters the value user must be se-
lected.
slow
For titrations in which the finest details are also to be visible. However, this
can also increase noise and lead to the production of unwanted EPs.
[ optimal ]
Parameter set for all standard titrations; optimized for the most frequent
applications.
fast
For less critical rapid titrations.