Metrohm tiamo 1.2 Manual - Handbuch (Seite 537)

Commands 511
Request for standard exchange
[ on ], off
If this option is enabled, a request for manual standard exchange is dis-
played after each measurement. This option must be disabled for auto-
matic standard exchange when calibrating with a Sample Processor.
CAL MEAS Conc
Measuring command for calibrating ion-selective electrodes. The command is
used together with the command CAL LOOP Conc .
Devices
This command can be executed with the following devices:
Titrando: 808, 809, 835, 836, 855, 857
Appearance
The command has the following appearance:
Parameters
The parameters for the command CAL MEAS Conc are configured on the following 2
tabs:
• General/Hardware
Parameters for device, sensor and stirrer.
• Measuring parameters
Parameters for the measurement.
General/Hardware
The general parameters for the control device, the sensor and the stirrer are de-
fined on this tab.
Command name
25 characters, [ CAL MEAS Conc # ]
Name of the command.