Metrohm 799 GPT Titrino Benutzerhandbuch
Seite 181
![background image](/manuals/586221/181/background.png)
3.2 Remote control commands
799 GPT Titrino
177
Setup.AutoInfo.C.B2 ON, OFF
Setup.AutoInfo.C.R2 ON, OFF
Setup.AutoInfo.I ON, OFF
Setup.AutoInfo.O ON, OFF
ON means that the Titrino reports automatically the moment the correspond-
ing change occurs.
.Status:
Global switch for all set AutoInfo.
.P
PowerOn: Simulation of power on (3.2.2.171). Not from mains.
Messages from node .T, Titrator:
.T.R
Ready: Status 'Ready' has been reached.
.T.G
Go: Instrument has been started.
.T.GC
GoCommand: Instrument (or submethod in TIP) has received a go
command.
.T.S
Stop: Status 'Stop' has been reached.
.T.B
Begin of sequence (or submethod).
.T.F
Final: End of determination (or submethod), the final steps will be
carried out.
.T.E
Error. Message together with error number, see page 111ff.
.T.H
Hold: Status 'Hold' has been reached.
.T.C
Continue: Continue after hold.
.T.O
Conditioning OK: EP reached (in SET, KFT with conditioning).
.T.N
Conditioning Not OK: EP not reached (in SET, KFT with condition-
ing).
.T.Re
Request: In the inquiry of an identification or the sample size after
start of titration.
.T.Si
SiloEmpty: Silo empty, i.e. the last line has been removed from
the silo memory.
.T.M
MeasList: Entry in the measuring point list (with DET, MET, STAT,
DOS, DOC, SET, KFT, MEAS).
.T.EP
EPList: Entry into EP list (with DET, MET, SET, KFT)
.T.RC
Results have been recalculated.
Messages from node .C, Comport:
.C.B1
COM1: A report is outputted on COM1. During this time, COM2
will be blocked. COM2 is generally blocked, if COM1 is busy.
.C.R1
COM1 is ready again. (Comes also when you <QUIT> an error.)
.C.B2, .R2 Identical for COM2.
Messages for changings in the I/O lines. If the changings are made simulta-
neously, there is 1 message. Pulses receive 2 messages: one message each
for line active and inactive.
.I
Input: Change of an input line.
.O
Output: Change of an output line (except 7, pin 2, for recorder
pulses).
If a change occurs that requires a message, the Titrino sends space (ASCII
32) and ! as an introducer. This is followed by the name of the device (see
3.2.2.106). Special ASCII characters in the device name are ignored. If no de-
vice name has been entered, only ! is sent. Finally the Titrino sends the infor-
mation which node has triggered the message.
Example: !John".T.Si": The message was triggered from instrument "John",
node .T.Si
3.2.2.170. Setup.Graphics.Grid ON, OFF
Setup.Graphics.Frame ON, OFF
Setup.Graphics.Scale Full, Auto
Setup.Graphics.Recorder.Right 0.2...0.5...1.00