Yamaha EMP700 - Handbuch (Seite 75)

3. Reception Conditions / Conditions de réception / Empfangsbedingungen
MIDI IN
[Channel Messages]
> PROGRAM CHANGE (CnH)
> OFF
> NOTE ON (9nH), NOTE OFF (8nH)
> CONTROL CHANGE (BnH)
> CHANNEL PRESSURE(DnH)
(System Exclusive Messages]
> BULK DUMP (FOH, 43H, OnH)
> BULK DUMP REQUEST (FOH, 43H, 2nH)
> BANK CHANGE REQUEST (FOH, 43H, OnH)
4. Reception Data / Réception des données / Empfangsdaten
4-1. Channel Information
[1] Channel Voice Messages
1) NOTE ON
Received on the channel specified for the selected bank when
a program with controllers 1 and 2 assigned to KEY NOTE or
KEY VEL. is active or when a pitch change group effect (TPI,
SPI, P+R, P—>R) and a parameter setting other than OFF are
selected.
When a message is received, the value of the assigned effect
parameter is changed according to the note number or velocity
value or the pitch change course value changes according to the
note number.
STATUS lOOlnnnn(9nH) nnnn = Channel No. *1
1st data Okkkkkkk kkkkkkk = Note No. *2
2nd data Ovvvvvvv vvvvvvv = Velocity *3
2) NOTE OFF
This message affects the EMP700 only when the equipment
signalling the end of a NOTE ON message is connected.
STATUS lOOOnnnn(8nH) nnnn = Channel No. *1
1st data Okkkkkkk kkkkkkk = Note No. *2
2nd data Ovvvvvvv vvvvvvv = Velocity *3
3) CONTROL CHANGE
Received on the channel specified for the selected bank when
a program with controllers 1 and 2 assigned to either 01 (MOD.
WHEEL) ~ 31 or 64 (SUSTAIN) ~ 95 is active.
When a message is received, the value of the assigned effect
parameter is changed according to the control value.
STATUS lOllnnnn(BnH)
1st data Occccccc
2nd data Ovvvvvvv
nnnn = channel No. *1
ccccccc = Control No. *4
vvvvvvv = Control Value *5
4) PROGRAM CHANGE
Received on the MIDI channel specified for the currently
selected bank.
When a message is received, the corresponding program is
called from the program change table of the selected bank.
STATUS llOOnnnn(CnH) nnnn = Channel No. *1
1st data Oppppppp ppppppp = Program No. *6
5) CHANNEL PRESSURE
Received on the channel specified for the selected bank when
a program with controllers 1 and 2 assigned to CH PRES, in the
UTILITY mode is active.
When a message is received, the value of the assigned parameter
is changed according to the pressure value.
STATUS llOlnnnn(DnH) nnnn = Channel No. *1
1st data Ovvvvvvv vvvvvvv = Pressure Value *7
Add-4